Model Listing (IM30)

To run IM30:

1. The Printer Selection screen automatically opens. Select the device destination and click OK.

2. The Report Parameters screen for IM30 opens.
   • The Format defaults to 'Model Listing' and cannot be changed.

   • The Sequence defaults to 'Model' and cannot be changed.

   • If a New Page for each Break is required, select the check box.

   • The Levels list box displays the various Levels of detail available for the report. All Levels are automatically selected in IM30; the '>' before each Level option indicates the Level is selected. The levels that display is dependent on the Sequence selected and can be modified.

   • There are no Restrictions that apply to this report.

   • Select the Range From and To for the report. The Range must match the Sequence selected. Multiple Ranges may be entered.
     • In the From field, enter the starting 'code' for the report.

     • In the To field, enter the ending 'code' for the report.

     • The information displays in the list box below.

     • To add additional Ranges, repeat these steps.

       Note: To print the entire file (all records in the selected sequence), simply tab through the From and To fields. The list box displays *Start and *End in the From and To fields.

     • To delete a Range from the list box, double click on the line. The following message displays, "Do you wish to delete this range? Yes/No". Click Yes to delete the range.

   • When all of the information on the Report Parameters screen is complete, click OK to run the report.

3. The Report Complete screen opens when the report is generated. Enter the Acceptance Codes to accept the report (if applicable), click OK to complete the printing of the report, or click Abort to cancel the report.

Here is an example of the IM30 report:

^{Model Listing - example}

Here is the Report Parameters window for IM30:

^{Report Parameters window for Model Listing (IM30)}